TURBOKLONE T48/96 PUMP

TURBOKLONE T48/96 PUMP – 450 GPH Replacement Water Pump for Aeroponic Cloning Systems

The TurboKlone T48/96 Pump is a replacement water pump designed to maintain reliable water circulation and consistent misting performance in compatible TurboKlone aeroponic cloning systems. Delivering a flow rate of approximately 450 gallons per hour (GPH), this pump supplies water and nutrient solution to the spray jet manifold, helping maintain the moisture levels required for successful plant propagation and root development. Ideal for replacing a worn or malfunctioning pump, it helps restore the performance of your cloning system and supports consistent coverage across all cloning sites.

Key Features

• 450 GPH flow rate for reliable water circulation in larger cloning systems

• Compatible with TurboKlone T48, T96 and Elite 96 cloning systems

• Designed to supply water and nutrient solution to the spray jet manifold

• Helps maintain consistent misting across cloning sites

• Compact design for convenient installation in compatible systems

• Suitable as a replacement for a worn, damaged or underperforming pump

• Designed to match the flow requirements of compatible TurboKlone systems

Application Guide

• Installation: Switch off and disconnect the cloning system from the power supply before removing the existing pump.

• Replacement: Remove the old pump and install the replacement, ensuring all connections and fittings are secure.

• Operation: Fill the reservoir to the recommended level and check that water circulates correctly through the manifold and spray jets.

• Maintenance: Periodically inspect the pump inlet, impeller and connections for debris, blockages or wear. Clean as required to help maintain consistent water flow.

Available Sizes

• 450 GPH Pump – designed for TurboKlone T48, T48 Special Edition and T96 / Elite 96 systems

• 250 GPH Pump – alternative flow-rate option designed for the TurboKlone T24